Whenever the water coming out of the faucets at home stinks, there may be an issue with your hot water heater. There are a couple of various causes of stinky water, yet the main cause is bacteria. If bacteria is entering into the water, a smell will likely come about. Well water is generally responsible for this taking place. However, there are a few actions a Kansas City homeowner may take to prevent bacteria from developing in their water and to get rid of current bacteria and smells.

According to Soquel Creek Water District, “The smell is the result of four factors that must all be present for the odor to develop. These factors include:

  • A high concentration of sulfate in the raw water
  • Sulfate reducing bacteria, non-toxic to humans (sulfate is reduced to a sulfide state by the bacteria)
  • Little or no dissolved oxygen in the water
  • Hydrogen (a component of water which may be present due to water conditions reacting with the anode)”  Read more here…

Protecting Against Water Heater Bacteria Growth

The best way to prevent bacteria from developing and producing unpleasant tastes and odors in one’s residence, is to be sure that the temperature is set at 140 degrees or higher on one’s hot water heater. At this climate bacteria can’t grow and will be killed. Whenever your water heater temp is set any lower than this, bacteria will not only survive but will multiply.

Cleaning Out Hot Water Heater BacteriaKansas City Water Heater Odors

In order to get rid of active bacteria and odors, one should apply chemicals to eliminate it. Chlorine bleach is the most powerful and complete chemical cleaner to utilize. If perhaps you are trying to clean out the water and get rid of the bacteria using bleach yourself, you should have an understanding of the complete process of doing so. First of all, the electric or gas going to the water heater has to be turned off. And then the cold water supply needs to be switched off. After that, you will need to turn on one of the hot water faucets inside the house. This allows air in the tank. Utilizing a garden hose, drain the water out of the hot water heater and shut the drain valve once all of the water is drained. Next, it’s time to pour in the bleach. One needs five ounces of chlorine bleach for each gallon of water the tank holds. Remove the flexible cold water hose and pour the bleach in the opening. In cases where the cold water hose isn’t flexible, it could be a good idea to call in an expert. Hook up the water line again and fill up the tank with water. It’s critical to close the hot water tap in the house once all the air is out of the pipe. It is likewise essential to run all of the taps that employ hot water within the property until you can smell the bleach. The bacteria that is inside the water heater could also be in water lines and taps which means that you should get rid of the bacteria in these areas also. Allow the bleach water stay in the tank and in the piping for approximately 3 hours while not utilizing any hot water. And then an additional flush is in order. After the tank is drained again, don’t add more bleach but fill it back up with water and let it sit in the tank and in the water lines for at least thirty minutes. Lastly, drain the water just as before and then refill the tank with water. Let all the hot water appliances in the house run until you can not smell bleach. Either switch the power on again or reignite the pilot and you will be good to go!

For any concerns about water odor, flushing a hot water heater, Kansas City water heater repairs, or other water heater troubles, call us!